Drop wire connector; Gauge range; 0.4 to 1.2 mm diameter; Insulation diameter; 5 mm maximum diameter
Pair connector:Gauge range; 0.4 to 1.2 mm diameter; Insulation diameter:3 mm maximum diameter
Current conducting capacity:20 A, 10 A per conductor for 10 minutes at least without causing deformation of the module.
Insulation resistance:Dry atmosphere; >1012 Ω; Damp atmosphere (ASTM D618, procedure F); >1012 Ω;
Salt fog (ASTM B117); >1010 Ω; Immersion in water (15 days in 3% NaCl solution); >1010 Ω
Contact resistance: Rmaterial + Rbridge contacts + Rwire contacts; <10 m Ω
Increase in contact resistance:After climatic tests; <2.5 m Ω; After 50 reinsertions; <2.5 m Ω
Dielectric strength; >3,000 Vdc for 1 minute¡£
Mechanical characteristics:
Pair/drop wire housing screw; Special passivated direct + lacquered Zamac alloy.
Drop wire housing body; Transparent polycarbonate
Body; Flame retardant (UL94);fiber-glass reinforced;polycarbonate
Insertion contacts; Tinned phosphor bronze
Ground contacts; Cu-Zn-Ni-Ag alloy
Continuity contacts; Tinned hard brass
Lower sealant; Polymeric resin
Upper cable sealant; Silicone fluid
Pair/drop wire bearing cover; Polycarbonate
Plug-in module body; Flame retardant (UL94);fiber-glass reinforced;polycarbonate
Plug-in module sealant; Gel
"O" ring; EPDM
Cable/drop wire membrane; Thermoplastic rubber
Box base and cover; Polycarbonate RAL 7035
Earthing assembly; Stainless steel
Grommet; EPDM
Plug-in module configuration:Continuity;230 V GDT
* Note; if > 20 A up to 30 A is required, this is possible using a different GDT.